atelier
le sur mesure
nous contacter
Garantie
nouveautes
bois
fers
wedges
putters
ladies
juniors
fin de serie
shafts
grips
accessoires
 
MALTBY Heads
   
 

CT250 FAIRWAY WOODS & HYBRIDS

 
Choose Between All-Stainless Or Composite Crown Fairway Models and All-Stainless Hybrids.
         
       
         
             

New for 2005 are the CT Fairway Wood and Hybrid lines, all designed to complement the Ultra Playability of the CT Driver models. All models incorporate high strength, light weight construction permitting the concentration of weight in the form of permanently mounted tungsten or stainless steel screws on the sole towards the rear and perimeter. This gives all of these models exceptional playability, with a lot of stability and an enhanced ability to pick the ball off the turf and up into the proper trajectory.

   

The Fairway Woods are available in two models: one in stainless steel and one with a graphite crown. The 17-4 stainless model is available as Tour-3, 3, 5, and 7 and woods. The Tour-3 has 12 degrees of loft, making it ideal as a high lofted, compact driver! The graphite crown model is available as 3, 5 and 7 woods. Both models have high strength 455 Maraging Steel forged faces, reducing the weight at the face and maintaining very high strength. The graphite crown model offers a slightly lower center of gravity to help get the ball to the optimum trajectory. Both models use four stainless steel screws to concentrate weight low and to the perimeter.

The CT Hybrid clubs are 17-4 stainless with a forged Maraging 455 steel face. The loft options of the H2, H3, H4 are designed to replace hard to hit long irons with clubs that yield a higher trajectory and more consistent ball flight. These hybrids were designed to be built slightly longer than long irons, but shorter than traditional fairway woods, making them easier to hit solid than fairway woods with more distance then long irons. Tungsten screws are used to concentrate weight low, and to the perimeter.

ALL MODELS FEATURE

  • Forged 455 Maraging Steel faces for reduced weight
  • Recommended ferrule MDFOWS

CT STAINLESS FAIRWAY FEATURE

  • 17-4 stainless four piece forged body
  • Maraging 455 Steel face
  • Stainless steel weight screws and locks for optimal weight distribution
  • Tour-3 wood with 12° loft, 3, 5 and 7 woods

CT GRAPHITE CROWN FAIRWAY FEATURE

  • 17-4 stainless steel body with graphite crown for lower C.G.
  • Maraging 455 Steel face
  • Stainless steel weight screws and locks for optimal weight distribution
  • 3, 5, and 7 woods

CT HYBRID FEATURE

  • 17-4 stainless steel body
  • Maraging 455 Steel face
  • Tungsten weight screws for optimal weght distribution
  • 16°, 20° and 24° lofts
   
   

SHAFT MATCH — CT FAIRWAY HYBRID GRAPHITE SHAFT

Maltby
CT-250 FAIRWAY/HYBRID SHAFTS

   
   

Compression coil technology in a fairway/hybrid shaft

  • Heavier weight to accommodate fairway woods
  • Designed for use with CT Fairway woods and Hybrids
  • Compression coil technology in a fairway/hybrid shaft

CT250 FAIRWAY/HYBRID SHAFT

   
   

CT250 FAIRWAY WOODS & HYBRIDS

 Fairway Wood avec capuchon
€129.00

Iron/Wood avec capuchon

€129.00

Fairway Wood Couronne Composite avec capuchon
€139.00